Shop

Headrest Lower Cover – White

GM Bucket Seat Headrest Lower Cover - Correct Pebble Grain Texture Nice Reproduction used by GM on there Bucket Seats from 1969 - 1972 $16.00 Each .

$16.00 Add to cart

Heat Shield (350 Exhaust Manifold)

Reproduction of the Driver Side Heat Shield Fits - 1968 - 1972 Buick 350 .

$99.00 Add to cart

Heat Shield (455 Exhaust Manifold)

Reproduction of the 1970 455 Driver Side Heat Shield. Can use on newer 455 Engines but a small notch will need to be cut near the rear of the Heat Shield - See Photos below . . . Fits - Buick 455 Photos below show the notch that may need to be cut in if used on new Exhaust Manifolds. This notch is approximately 1" wide.

Close up of notch "cut out" towards the rear of the Heat Shield.

$109.00 Add to cart

Heat Shield (Motor Mount)

Reproduction Heat Shield for the Passenger Side Motor Mount Fits 400 - 430 - 455

$25.00 Add to cart

Heat Shield (Starter)

Reproduction Heat Shield found on Buick Engines Fits 350 - 400 - 430 - 455

$39.00 Add to cart

Heat Stove – 350

This is an OEM Part Fits 1970 – 1972 Skylark, GS & GSX with 350 Engine. (maybe other years as well) These are NOT currently reproduced and somewhat hard to find. It’s been cleaned, bead blasted and painted with High Temp Primer . . This Part has Sold Out but we leave hard to find parts like this on the website so you can use the photo and information to help locate one! . OEM Parts are Original Equipment that came off a “Parts Car”. Any of our OEM Parts will always be at least “Driver Quality”

$0.00 Read more

Heat Stove – 455

This is an OEM Part Fits 1970 – 1972 Skylark, GS & GSX with 455 Engine These are NOT currently reproduced and somewhat hard to find in nice condition. Very little Pitting on this one! It's been cleaned, bead blasted and painted. . This Part has Sold Out but we leave hard to find parts like this on the website so you can use the photo and information to help locate one! . . OEM Parts are Original Equipment that came off a “Parts Car”. Any of our OEM Parts will always be at least “Driver Quality”

$0.00 Read more

Heat Stove Mounting Bolts (Pair)

Heat Stove Mounting Bolts - Sold as a Pair (Requires 2) Fits 1970 - 1972 Source - Stage 1 Restoration Stage 1 Restoration has the most hardware of any vendor for the 1970 – 1972 GS / GSX & Skylark Models. Don’t see what you need ? Give me a call, we probably have it!

$2.00 Add to cart

Heat Stove Pipe (Black)

This is the Black Piping that goes from the heat stove to the bottom side of the Air Cleaner Assembly Also called a "Pre Heat Tube" Fits 1970 - 1972 (Maybe More) Note: Our Heat Stove Pipe is the correct length. Be aware of other Vendors not providing a long enough piece! Black was typically used on the GS, GSX & Skylark Models. We know our parts fit because we use them in our Restoration Shop!

Installation Tip: The Heat Stove Pipe "Threads" onto the Air Cleaner Elbow. Install this end 1st then it simply slides onto the Heat Stove. The picture below shows the "threads" that the heat stove utilizes . . . .